standard hammer and hacksaw.
10 inch steel spikes with a 3/8 inch diameter.
For patios and walkways, use 1 spike every 16 to 20 inches and at each end. For driveways and heavy load areas, use 1 spike every 8 to 12 inches and at each end.
Determine the amount of edging required by measuring the exterior perimeter of the project.
Prepare and compact the base as recommended by the paver manufacturer for your area. Base should extend at least 6 inches beyond the edging.
Spread 1/2 to 1 inch of sand over the installation area and level to a uniform depth prior to setting the pavers.
Set pavers according to your design requirements. Once completed, compact the pavers using a vibrating compactor. Start at the outer edges and work towards center. Spread coarse sand over entire project sweeping the sand in between the pavers. Compact again until all pavers are level and all joints are tight.
Lay the material along the perimeter of the pattern with the tabs facing inwards. Material can be easily bent by hand to form any curve or angle. 90 degree angles may be formed as often as every 4 inches without cutting the material. If your project requires bending between a V-shaped cutout, cut your own V using tin snips.
Push down edging lightly to set the material into base, anchoring with spikes as you go. Once the desired length has been reached, cut off excess material using a hacksaw. Anchor material at both ends using spikes.
Bring areas adjacent to the pavers up to the desired level using rake to move the soil or sod. Edging should not be visible when the project is completed.